Darley Nomex® Champion™ Gear Pants
Our gear is built to hold up in the toughest of conditions and is loaded with all the features you expect including plenty of large pockets and clips for your tools and communication equipment, reinforced knees, double stitched seams and comfortable overlapping collar. Your safety is most important so we’ve included bright, reflective 3M triple trim, a fire resistant Nomex® IIIA outer shell and drag rescue Device per the latest NFPA safety standard. Turnout Gear worthy of a Champion.
- Overlapping collar - throat protector with Velcro® closure
- Mic clips - left and right chest Nomex® mic clips
- Radio pocket - 9" x 3" x 2" with double notch flap
- Embroidered patch - durable stitching
- Coat closure - inner hook and loop, outer hook and Dee
- Coat cuffs - polymer coated Kevlar® cuff and shoulder reinforcement
- Patch pockets - (2) 10" x 10" pockets with drainage holes
- Reflective trim - 2” 3M Scotchlite™ lime/silver triple trim on coat and pants
- Removable DRD - Drag Rescue Device
- Coat liner - Nomex® Q8 with Stedair 3000 viral barrier
- Suspenders - Red with leather ends
- 32" coat - Nomex® IIIA outer shell
- Reinforced knees - polymer coated knee and cuff reinforcements
- Pants - Nomex® IIIA outer shell
- Pant liner - Nomex® Q8 with Stedair 3000 viral barrier
- Pant closure - Inner hook and loop, outer hook and Dee
- Bellows pockets - (2) 10" x 10" full bellows pockets
- Take-up straps - Fabric with postman slides
Darley Nomex® Champion™ Turnout Gear Size Chart
Turnout Gear Measuring
Chest
Measure at chest, just below armpits. Bigger is usually better for fit and comfort. Even numbered sizes only (32", 34", etc.) When ordering general sizes, you will receive chest size pertaining
to size charts (See sizing chart pages). For general sizing, the larger of the two numbers in each category is manufactured.
Sleeve
Measure sleeve lengths from the middle of the back from the vertebrae at the base of the neck, over the shoulder and down to the base of the thumb. Longer is usually recommended for better protection. Do not bend arm. If not standard size, an additional “custom” sleeve length charge will apply.
Waist
Measure sleeve lengths from the middle of the back from the vertebrae at the base of the neck, over the shoulder and down to the base of the thumb. Longer is usually recommended for better protection. Do not bend arm. If not standard size, an additional “custom” sleeve length charge will apply.
Inseam
Inseam is measured well up in the crotch area to that point on the foot that is required. Choose a shorter length than you usually wear for a better fit and comfort. Standard inseam is 28" - 30". This is appropriate for anyone between 5'9" and 6'2". For inseams 33" to 36", add 10%, 37" and up, add 20% to shell and liner.
Hips (Ladies Only)
Measure hips at the widest point.
Suspenders (Measuring Instructions Not Shown)
Suspenders are measured from the rear suspender post over the top of the shoulder to the front suspender post. Correct rise pants and rear bib size need to be used.
Darley
View more by DarleyDarley Exclusive gear is our private label line of firefighting equipment. Only the best products wear the Darley logo.
| Manufacturer | Darley |
|---|
